Search AP Chemistry

Groups and Families

Practice: Start 10 random questions on this lesson · Pick your own set

On this page 4 sections
  1. 1. Building the periodic table (7.1)
  2. 2. Metals, nonmetals, and metalloids (7.6)
  3. 3. Group 1 and Group 2 metals (7.7)
  4. 4. Selected nonmetals (7.8)

The teacher’s Exam 3 note says to read Chapters 6 and 7 for theory, and the Chapter 7 questions cover “PT trends and such.” This lesson covers the parts of Chapter 7 the other lessons skip: where the table came from, and how whole groups behave.

1. Building the periodic table (7.1)

  • Mendeleev (1869) arranged the known elements in order of atomic mass, grouping elements with similar properties in the same column. He left gaps for elements nobody had found yet and predicted their properties. When gallium and germanium were discovered, they matched his predictions.
  • A few elements end up out of order by mass (tellurium is heavier than iodine, but iodine clearly belongs with the halogens).
  • Moseley (1913) used X-rays to show that each element has a different atomic number, the number of protons. Ordering by atomic number fixes the out-of-order pairs, and that’s how the modern table is arranged.

2. Metals, nonmetals, and metalloids (7.6)

PropertyMetalsNonmetalsMetalloids
Whereleft and middleupper rightalong the staircase (B, Si, Ge, As, Sb, Te)
Look and feelshiny, malleable, ductiledull; solids are brittlein between
Conduct heat and electricitywellpoorlysomewhat (semiconductors, like Si)
Ionization energylowhighin between
Ions formedcationsanions (with metals)rarely ions
Oxidesbasic ionic solidsacidic molecular oxidesin between

Metallic character increases down a group and to the left, the opposite direction from ionization energy. The lower the IE, the more easily the atom gives up electrons and the more “metal-like” it is.

Oxides as acids and bases

  • A metal oxide dissolved in water makes a metal hydroxide (a base):

    NaX2O(s)+HX2O(l)→2 NaOH(aq)\ce{Na2O(s) + H2O(l) -> 2NaOH(aq)}

    Metal oxides also react with acids to make a salt and water:

    MgO(s)+2 HCl(aq)→MgClX2(aq)+HX2O(l)\ce{MgO(s) + 2HCl(aq) -> MgCl2(aq) + H2O(l)}
  • A nonmetal oxide dissolved in water makes an acid:

    COX2(g)+HX2O(l)→HX2COX3(aq)\ce{CO2(g) + H2O(l) -> H2CO3(aq)} SOX3(g)+HX2O(l)→HX2SOX4(aq)\ce{SO3(g) + H2O(l) -> H2SO4(aq)}

    Nonmetal oxides react with bases to make a salt and water:

    COX2(g)+2 NaOH(aq)→NaX2COX3(aq)+HX2O(l)\ce{CO2(g) + 2NaOH(aq) -> Na2CO3(aq) + H2O(l)}

3. Group 1 and Group 2 metals (7.7)

Alkali metals (group 1: Li, Na, K, Rb, Cs)

  • Soft (they can be cut with a knife), shiny, and with low melting points and low densities.
  • One valence electron (ns1ns^1) and the lowest ionization energies in their periods, so they lose that electron easily and form +1+1 ions.
  • They’re so reactive they’re never found free in nature, and they’re stored under oil.
  • They react with water to make hydrogen gas and a hydroxide:
2 Na(s)+2 HX2O(l)→2 NaOH(aq)+HX2(g)\ce{2Na(s) + 2H2O(l) -> 2NaOH(aq) + H2(g)}
  • Reactivity increases going down the group (Li → Cs), because IE gets lower as the valence electron gets farther from the nucleus. Potassium reacts with water more violently than sodium.
  • They react with nonmetals to form ionic compounds: 2 Na+ClX2→2 NaCl\ce{2Na + Cl2 -> 2NaCl}.
  • Their compounds give flame colors: lithium red, sodium yellow-orange, potassium violet.

Alkaline earth metals (group 2: Be, Mg, Ca, Sr, Ba)

  • Harder, denser, and higher-melting than the alkali metals.
  • Two valence electrons (ns2ns^2), so they form +2+2 ions. Their first IE is higher than group 1’s, so they’re less reactive than the alkali metal next to them.
  • Reactivity again increases down the group. Be doesn’t react with water, Mg reacts only slowly (faster with steam), and Ca and the ones below it react readily:
Ca(s)+2 HX2O(l)→Ca(OH)X2(aq)+HX2(g)\ce{Ca(s) + 2H2O(l) -> Ca(OH)2(aq) + H2(g)}

4. Selected nonmetals (7.8)

Hydrogen

Hydrogen sits above group 1 because of its 1s11s^1 configuration, but it’s a nonmetal. Its IE is far higher than the alkali metals’. It usually forms molecular compounds by sharing electrons (like HX2O\ce{H2O}), and with very active metals it can gain an electron to form the hydride ion, HX−\ce{H-} (as in NaH\ce{NaH}).

Group 16: oxygen

  • Oxygen exists as OX2\ce{O2} and as ozone, OX3\ce{O3}. Two forms of the same element are called allotropes.
  • Oxygen is very electronegative (second only to fluorine). It usually forms oxides containing OX2−\ce{O^2-}, but peroxides (OX2X2−\ce{O2^2-}, as in HX2OX2\ce{H2O2}) also exist.
  • Going down group 16 (O, S, Se, Te, Po), metallic character increases. Sulfur commonly exists as SX8\ce{S8} rings.

Group 17: the halogens

  • They exist as diatomic molecules: FX2\ce{F2} and ClX2\ce{Cl2} are gases, BrX2\ce{Br2} is a liquid, and IX2\ce{I2} is a solid at room temperature.
  • With seven valence electrons and very negative electron affinities, they gain one electron to form −1-1 ions (halides).
  • Reactivity decreases going down the group. Fluorine is the most reactive element of all.
  • A more reactive halogen takes electrons from the halide ion of a less reactive one:
ClX2(g)+2 NaBr(aq)→2 NaCl(aq)+BrX2(aq)\ce{Cl2(g) + 2NaBr(aq) -> 2NaCl(aq) + Br2(aq)}

The reverse, BrX2\ce{Br2} with NaCl\ce{NaCl}, doesn’t happen.

Group 18: the noble gases

  • Monatomic gases with filled ns2 np6ns^2\,np^6 shells (He is 1s21s^2). They have very high IEs and positive electron affinities, so they’re very unreactive.
  • They aren’t completely inert, though. The heavier ones have lower IEs, and xenon forms compounds with the most electronegative elements, such as XeFX2\ce{XeF2}, XeFX4\ce{XeF4}, and XeOX3\ce{XeO3}. Krypton forms KrFX2\ce{KrF2}. No compounds of He, Ne, or Ar are known under normal conditions.